The E-25C provides twisted pair connectivity to an Ethernet network.

Cable requirements:

  • 10BaseT (Ethernet): Unshielded Twisted Pair (UTP), Category 3 or higher
  • 100BaseTX (Fast Ethernet): UTP, Category 5 or higher (4-pair/8-wire, short length)
  • 1000BaseT (Gigabit Ethernet): UTP, Category 5e or higher (4-pair/8-wire, short-length)

  • If the print engine is 230V, use a shielded network cable.
  • Before connecting the cable, ground yourself by touching a metal object.

  1. Turn OFF the E-25C power before connecting the E-25C to any network device.
  2. Connect the end of the network cable with the core attached to the LAN port on the E-25C.
  3. Connect the other end of the cable to the customer's network, such as hub connector.
  4. Make sure that the copier power is switched on.
  5. Turn ON the power switch on the E-25C rear panel.
  6. Press and release the soft power push button on the front panel of the E-25C.
  7. Allow startup to proceed without interruption, while you watch the diagnostic LED on the rear panel of the E-25C. When the diagnostic LEDs show '00', go to the copier operation panel.
  8. Press the Home button on the operation panel of the copier and wait for a few minutes until the Fiery icon appears on the Home screen.
  9. Touch the Fiery icon and wait about a few minutes until the Fiery menu screen appears.
  10. Move to the Fiery tab.
  11. Touch the "Setup" button.
  12. Enter an administrator password. (The default is "Fiery .1")

  13. Ask the site administrator to configure the Setup options.

    • It is the site administrator's responsibility to configure the correct setup options for the network and user environment. The default settings in the setup may be adequate, but they may not be optimal for the user's environment. Refer the site administrator to the "Configuration and Setup" manual for setup information.

  14. After configuring the Setup options, verify the network connection.
  15. Print the configuration page and backup the initial configuration settings by going to WebTools > Configure > Fiery Server > Backup. [Link to Backing Up/Restoring the System Configuration and Selected Settings Only]
  16. Make sure that the system date and time, and the time zone have been adjusted before leaving the customer site. [Link to Adjusting the System Date and Time]
  17. Ask the site administrator to install the printer driver and utility software on a client PC, and make a test print from that PC.