Once you install and connect the E-25C with the copier (IM C3000 / IM C3500 / IM C4500 / IM C5500 / IM C6000), E-25C will be configured as follows during the initial boot-up.
Compatibility table
S: Supported
NS: Not Supported. Execute “Factory Default” to support the copier.
Refer to the above compatibility table, if you plan to pre-install and pre-configure the E-25C before customer site installation, or if the copier model in use with the E-25C is to be changed.
For example, if the copier in use by the customer is C5500, E-25C needs to be pre-installed and pre-configured with C5500 or C6000 or C4500.
If the configured E-25C is connected to an incompatible copier model (= NS in the above table) at a later time, "Invalid engine configuration" error appears on the operation panel as shown below. Printing is not possible at this state.
To enable printing, re-configure the E-25C with the copier in use, execute the "Factory Default" (Restoring the E-25C to Factory Defaults) and follow the installation procedure once again.