Virtual Machine Unit for TotalFlow Print Server Type S9

Accessory Check

Installation Procedure

1. Push the lever [A] and slide the left cover [B] backward.
   
2. Push the lever [A] and pull out the HDD bracket [B].
   
3. Attach the HDD bracket to the HDD. (hook x 4)
   
4. Insert the HDD with bracket [A] into the machine.
   
5. Connect the power cord [A] and SATA cable [B] to the HDD.
   
6. Push the flat spring [A] to open the rear cover [B].
   
7. Remove the PCI slot covers [A].
   
8. Attach the USB board.
   Use one of the screws you removed in step 7.
   
9. Open the clamp [A] and connect the P10 connector [B] to the USB board.
   
10. Attach the graphic board.
    Use one of the screws you removed in step 7.
    
11. Close the rear cover.

12. With the power of the print server turned off, reconnect the mouse/keyboard/display cables to the newly installed option boards.
    

13. Press the power switch and press the DEL key repeatedly until the Setup Utility screen appears.
    

14. Open the following menu using the arrow keys.
    Advanced > Chipset Configuration > System Agent (SA) Configuration > Graphic Configuration

15. Set "Internal Graphics" to [Disabled].
    

16. Press the ESC key three times to return to the top menu of the Setup Utility.

17. Move to the "Save & Exit" menu and select [Save Changes]. When "Save configuration?" appears, select [Yes].

18. Select [Discard Changes and Exit]. When "Quit without Saving?" appears, select [Yes].

    

    You must reboot the Print Controller after you install Virtual Machine Unit and change the BIOS setting as above. When the reboot is completed, please check whether or not Windows Configuration Wizard of TotalFlow Prep is displayed on the monitor. If the Wizard is displayed correctly, please ask the customer to configure it. (Windows Configuration Wizard of TotalFlow Prep must be configured by the customer.)