• Before installing this fax unit, print out all data in the printer buffer. Turn the main power to OFF and disconnect the power cord and the network cable.

  1. Remove the I/F cover [A].
  2. Remove the interface slot cover [A].
  3. Remove the "TEL" [A] and "LINE1" [B] covers on the interface slot cover using a screwdriver.
  4. Switch the battery jumper switch [A] to the "ON" position.
  5. Attach the slot cover [A].

  6. Insert the FCU [A] completely into the interface slot.

    • Insert the FCU board along the rail [A].

  7. Reattach the interface slot cover [A].
  8. Reinstall the I/F cover ( x 3).

  9. Attach the handset support bracket and handset bracket to the machine. To install the handset, connect the handset cord with the ferrite core to the "TEL" jack.

    Taiwan only: Install the telephone jack cap in the "TEL" jack if the handset is not installed on the machine.

  10. Make one loop with the telephone cord, and then attach the ferrite core [A] (this step is not needed for NA).
  11. Connect the telephone cord to the "LINE 1" jack.
  12. Attach the clamp [A] as shown in the picture below, and put the cable in the narrow space [B].
  13. Attach the serial number decal under the machine serial number decal on the rear cover of the machine.
  14. Attach the FCC decal to the rear cover of the machine (NA only).

  15. Insert the power plug into the outlet. Turn ON the main power of the machine.

    • Make sure that the outlet is grounded.
    • "SRAM formatted" is displayed on the operation panel after the main power is turned ON. Turn the main power OFF and then ON again for normal use.

  16. Make sure that the date and time are correctly set.
  17. Execute SP3-102-000 in the fax SP mode and enter the serial number for the fax unit.
  18. Enter the correct country code with SP1101-016(SYS OF): Country/area code for functional setting.