Use the "Skew Correction Reference Diagrams" and "Skew Correction Reference Table" in the previous section to determine the location of the skew and which stopper needs adjustment.
Now you are ready to do the adjustment on the multi-folder unit.
The illustration above shows the location for each stopper adjustment.
Each stopper is equipped with two screws.
The black plastic screw is the set screw and the metal silver screw is the adjustment screw.
- Before the adjustment, mark the location of each adjustment screw.
Remove the set screw.
Turn the adjustment screw to do the adjustment for the stopper.
1st, 3rd Stopper
Turn the Adjustment screw clockwise to lower the front end of the fence.
-or-
Turn the Adjustment screw counter-clockwise to raise the front of the fence.
2nd Stopper
Turn the Adjustment screw clockwise to raise the front end of the fence.
-or-
Turn the Adjustment screw counter-clockwise to lower the front of the fence.
Fasten the set screw in the hole of the diagonal cutout near the hole where you removed it.
- The diagonal cut may be above or below the original hole, depending on which stopper you are adjusting.
- The photo above shows the set screw for Stopper 2.
Tighten the set screw so that the plate holds the adjustment.