1. First fold unit (First Fold Unit)

  2. First fold roller gear [A] ( x 1, pin x 1, spacer x 1)

  3. Pressure release bracket [B]

  4. Rear cam gear [A] ( x 1, timing belt x 1)

  5. Bushing [B] ( x 1)

  6. Rear tension bracket [C] (spring x 1, x 1)

  7. Rear bracket [A] ( x 3)

  8. When removing the rear bracket, slide the fold assist plate [B] in the arrow direction.

  9. Remove the gear [A] ( x 1)

  10. Remove six gears (clip x 6, pin x 1 each for four gears [A]).

  11. Cam gear [B] ( x 1, pin x 1)

  12. Remove the gear links [A].

  13. Front tension bracket [B] (spring x 1, x 1)

  14. Front shaft holder bracket [C] ( x 1, bushing x 1, spacer x 1)

  15. Front bracket [A] ( x 2)

  16. Third fold roller [A] with the guide plate and direct send junction gate [B].

  17. Second fold roller [C]


    • [D]: Third fold roller with the guide plate and direct send junction gate

    • [E]: Second fold roller

    • When re-assembling the third fold roller with the direct send junction gate and guide plate, install the guide plate [A] and direct send junction gate [B] in the third fold roller unit as shown below. (The arms of the guide plate should be placed on the outer side of the arms of the direct send junction gate.)

  18. First fold roller with roller bracket [A]

    • When reinstalling the first fold roller, insert the white pivot [A] in the rail [B].
    • Make sure that two projections [C] hook onto the stay bracket [D].

  19. Roller stopper [A]

  20. Roller bracket [A]

  21. First fold roller [B] (spacer x 1)