The jogger unit uses only the main jogger to align paper sizes smaller than 300 mm. The sub jogger does not operate.
Set 1
- The shift motor switches on and off, moving the shift rollers and each sheet 10 mm to the rear.
- The leading edge of each shifted sheet output to the shift tray is aligned by the leading edge stopper
.
- The main jogger rear and front jogger fence motors switch on and push the rear and front fence against the shifted edge of the stack at
and
.
- The front fence moves on top of the stack below. The front fence is light so it does not interfere with the top sheet of the stack below.
- After the last sheet of the set has fed and been aligned, the main jogger retraction motor raises both fences and positions them at the front for the next set.
Set 2
When the next set (blue above) is output to the shift tray in shift mode:
- The shift motor switches on and off, moving the shift rollers and each sheet 10 mm to the front.
- The leading edge of each shifted sheet output to the shift tray is aligned by the leading edge stopper
.
- The main jogger front fence and rear fence motors switch on and push the front and rear fence against the edges of the stack at
and
.
- The rear fence moves on top of the stack below. The rear fence is light so it does not interfere with the top sheet of the stack below.
- After the last sheet of the set has fed and been aligned, the main jogger retraction motor raises both fences and positions them at the rear for the next set.
At the end of the job, the rear and front fence motors reverse and move the rear and front fences back to the home position and stop.
The stack is jogged at three points: at the leading edge by the LE stopper, and at the front and rear of the trailing edge by the main jogger unit.