1. Remove the screw.
  2. Open the bypass tray.
  3. Pass the harness [A] through the hole [B].
  4. Separate the paper feed unit [A] and bottom plate [B] of the bypass tray unit.
  5. Disconnect the arm [A] at the front side.
  6. Disconnect the arm [A] at the rear side.
  7. Remove the bypass tray [A].

  8. Remove the arm [A].

    • Move the arm out of the hole, or the harness might be snapped.

  9. Remove the bottom plate [A] of the bypass tray.
  10. Turn over the bypass tray [A], then disconnect the connectors and clamps of the bypass paper width sensor [B] / bypass paper length sensor [C].