[A]: Tray 1 paper feed belt unit

[B]: Tray 2 paper feed belt unit

  1. Open the paper tray.
  2. Remove the lock of the paper feed belt unit (x2).
  3. Hold the knob of the paper feed belt unit [A] and pull out the paper feed belt unit [A].

  • The paper feed belt unit must be pulled out horizontally relative to the paper tray, to ensure that the paper feed belt is not damaged by getting caught in the side fences or other parts.
  • To prevent damaging the paper feed belt when you return the paper feed belt unit to its original position, align the right and left guides [A] with the rails [B] on the paper tray side and raise them slightly before replacing the unit.

 

Installing the paper feed belt unit
  1. Attach the paper feed belt unit [A].
  2. Check that there is no gap at the position indicated by the red dotted circle. Then, secure the paper feed belt unit firmly with two screws.


    If there is a gap, proceed to the following step.


  3. If there is a gap, pull out the paper feed belt unit [A], rotate the paper feed belt [B] upwards to change the position of the rear spring pin and coupling position slightly and then set the paper feed belt unit again. Repeat it until the paper feed belt unit is tightly attached and there are no gaps between the frames.