1. Open the ID card tray [A].

  2. Open the DF, and cover the exposure glass with a mat [A] or something to prevent it from being damaged.
  3. Remove the two screws of the ID card feeder [A], and place it on the mat gently.

  4. The harness [A] of the ID card set sensor is connected, and so the ID card feeder itself cannot be removed.

  5. Remove the stopper [B] of the original rear side CIS [A].

  6. Release the tab [A], and place the original rear side CIS [B] on the mat.

  7. Disconnect the FFC, and remove the original rear side CIS [A].

    • Make sure not to bend or deform the leaf springs [A]

  8. After replacing, do the AGC adjustment for the original rear side CIS. (AGC Adjustment for the Original Rear Side CIS)

When attaching the ID card feeder, be sure to begin with the screw [A] at the bottom (rear).