1. Remove the following covers. Covers
    • Front door
    • Front left side cover
    • End fence
    • Rear upper cover
    • Rear lower cover

  2. Pull out the booklet stapler unit, and remove the inner upper cover [A]. ( x 2)

    • Disconnect the harness from the back side of the inner upper cover when you remove the inner upper cover.

  3. Remove the screws from the front side of the finisher. ( x 6)
  4. Remove the bushing [A] from the front side of the finisher. (x1)
  5. Remove the pressure release motor bracket [A] from the rear side of the finisher. ( x 2)
  6. Remove the gear [A] from the rear side of the finisher. (x 1)
  7. Remove the pulley [A] from the rear side of the finisher. (x 1)
  8. Remove screws from the rear side of the finisher. ( x 6)
  9. Remove the clamps shown below. ( x 6)
  10. Disconnect the ground wire [A] of the main board. ( x 1)
  11. Disconnect the connectors shown below. ( x 8)
  12. Pull out the harnesses disconnected in step 11 to the right side of the finisher through the hole [A].
  13. Remove the harness from the clamps. ( x 4)
  14. Remove the corner stapling unit [A] from between the front and left plates.