1. Remove the paper exit guide.
  2. If the Output Jogger Unit Type M25 (option) unit is installed, remove it.
  3. Remove paper guide cover support bracket [A] (x2).

  4. At the front and back remove the shoulder screws [A] and [B] of the output jogger unit if it was installed.

    • Removing the jogger unit makes it easier to access the paper guide unit fastening screws. Do not lose these screws.

  5. Loosen the proof tray screws temporarily to make it easier to reach the paper guide fastening screws.
  6. Remove the paper guide fastening screws at the front [A] and rear [B] (x4).
  7. At the rear, open the clamp, and then disconnect the motor and sensor (x2, x2).
  8. Tilt the paper guide unit toward you, and then disconnect the harness of motor bracket [A].
  9. Remove the paper guide unit and place on a flat, clean surface.