No. | Area |
1 | Cover Interposer Tray for Perfect Binder Type S1 |
2 | Vertical Path (Covers from Inserter) |
3 | Horizontal Paper Path |
4 | Signature Path |
5 | Stacking Tray |
6 | Main Grip Unit |
7 | Gluing Unit |
8 | Cover Registration Unit |
9 | Signature Rotation Unit |
10 | Trimming Unit |
11 | Trimming Buffer Unit |
12 | Trimmings Box |
13 | Book Buffer |
14 | Book Output |
Part | By | At | Action | Note |
|---|---|---|---|---|
Paper Transport | S | 500K | I | Paper wrinkled, creased, torn? |
Operation | S | 500K | I | Operation correct? |
Display Check | S | 500K | I | Correct messages displayed for mode, door opened, etc.? |
Covers | S | 500K | I/C | Damp cloth, check for damage |
Safety | S | 500K | I | Spurious noise during operation? |
Other | S | 500K | I | Used within specifications? |
Drive Rollers | S | 500K | I/C | Alcohol damp cloth |
Idle Rollers | S | 500K | I/C | |
Anti-static Brush | S | 500K | I/C | |
Bearings | S | 500K | I/C/L | Silicone oil |
Sensors | S | 500K | I/C | Blower Brush |
Blade | S | 4000K | R*1 |
|
Trimming Buffer Unit | S | 4000K | R*2 | |
Blade Cradle | S | 1000K | R*1 |
|
Cover Unit Switchback Roller Torque Limiter | S | 3000K | R*3 |
|
Signature Thickness Sensor | S | 14300K | R*3 |
|
Gluing Unit | S | 2000 hr. | R | 2000 hours |
Book Rotation Unit Diode | S | 14300K | R*3 |
|
Trimmings Buffer Motor | S | 14300K | R*3 |
|
Main Grip Unit Gears | S | 14300K | R*3 |
|
Torque Limiter (Signature Rotation Unit for Trimming) | S | 14300K | R*3 |
|
Spine Fold Unit Harness (Left) | S | 14300K | R*3 |
|
Spine Fold Unit Harness (Right) | S | 14300K | R*3 |
|
Pickup Roller | S | 286000K | R*3 |
|
Separation Roller | S | 286000K | R*3 |
|
Feed Roller | S | 286000K | R*3 |
|
Magnetic Clutch | S | 286000K | R*3 |
|
Separation Roller Torque Limiter | S | 286000K | R*3 |
|
*1 A message on the operation panel alerts the operator when it is time to replace this item.
*2 This item should always be replaced with the blade.
*3 Separate counts are logged for the operation of these items, because they will not be the same as the sheet counts for the main machine (the finisher will not be used for every job so the counts will be different). Be sure to replace these items after their individual counts have been exceeded.