1. Remove all the covers. (Right Front Cover, Left Front Cover, Rear Cover, Top Cover)
  2. Disconnect the ground wire and open the clamps .
  3. Disconnect the harnesses.
  4. At the front, disconnect hinge plate [1] and swing the hinge plate to the right (x1).
  5. At the rear, disconnect hinge plate [2] (x1).
  6. Carefully disconnect the hinge and spring [3].
  7. Pull the harnesses through the frame [1].
  8. Remove the feed tray [2].

  9. Turn over the feed tray. There are three sensors on the bottom of the feed tray.

    Paper end sensor

    Paper width sensor

    Paper length sensor