• After adjusting the Leading Edge Registration and Side Registration settings (see the previous section), do the Erase Margin Adjustment. To do this, check the values of Margins A and B.
  • If they are not within the specifications (see below), then adjust A and B with SP2-103-001 to -004 as explained below. Then check Margins C and D again.

[1]: Feed direction, [2]: Image area

  1. Enter the SP mode.
  2. Print out the test pattern (14: 1-dot trimming pattern) with SP2-109-003.
  3. Check the erase margin A and B. Adjust them with SP2-103-001 to -004 if necessary.
    • Leading edge: 0.0 to 9.9 mm (default: 4.2 mm)
    • Side-to-side: 0.0 to 9.9 mm (default: 2.0 mm)
    • Trailing edge: 0.0 to 9.9 mm (default: 4.2 mm)