1. Remove the slot cover [A].

  2. Insert the Gigabit Ethernet controller [A] and fasten it (knob-screw x 2).

  3. Connect the interface cable to the copier Gigabit Ethernet connector.

    If the cable is too long, wind it into a circle. Make sure that the radius [1] is 100 mm or longer.
  4. Connect the power cord of the copier to a power outlet.
  5. Connect the interface cable [A] to the lower Ethernet port of the E-25C.
  6. Connect the appropriate AC power cord [B] to the power connector at the rear of the E-25C.
  7. Attach the Fiery Decal [A] to the copier front cover.