Skip header
 

Top Page > Troubleshooting: Paper Delivery Problems > Paper Feed Problems (Input Tray) > J099 Appears (Vacuum Feed LCIT) > No Feeding

No Feeding

This problem is caused by a variety of factors. Implement the following measures.

Note

  • If no feeding occurs when feeding remaining uncoated paper in tray, try feeding again through paper tray of main machine, instead of the vacuum feed LCIT

  1. Remove the paper from the paper tray and fan the paper.

    char_ric91.gif If the problem occurs again, proceed to the next step.

  2. Attach the Tab Sheet Holder. See Attaching the Tab Sheet Holder (Vacuum Feed A3 LCIT).

    char_ric91.gif If the problem occurs again, proceed to the next step.

  3. Clean the feed unit.

    char_ric91.gif If the problem occurs again, proceed to the next step.

  4. In Custom Paper Settings, set 118: [Paper Feed Mode (Adjust Fan Level)] to “Moderate Nonfdg Red. (Higher)”.

    char_ric91.gif If the problem occurs again, proceed to the next step.

  5. In Custom Paper Settings, set 118: [Paper Feed Mode (Adjust Fan Level)] to “Max Nonfdng Reduc. (Highest)”.

    char_ric91.gif If the problem occurs again, proceed to the next step.

  6. In Custom Paper Settings, change 117: [Switch Paper Load Upper Limit] from [Low] (18mm) to [High] (12mm).

    char_ric91.gif If the problem occurs again, proceed to the next step.

  7. Manually adjust the paper load upper limit. See J430, 431,445, 446, 460, or 461 Appears.

    char_ric91.gif If the problem occurs again, proceed to the next step.

  8. Clean the paper feed belt. See J430, 431,445, 446, 460, or 461 Appears.