SC300 (Image Processing – 1)

SC302-00

D

High voltage output error: Charge unit /Development unit

This SC is issued if the engine board detects a short in the power pack 10 times consecutively.

Open circuit (+) / Short circuit (-)

• Turn the main power off/on.

• Replace the board.

• Check the connector connection.

SC332-00

D

Toner supply transfer lock

This SC is issued if the error that the toner is not supplied is detected n times consecutively (n: SP2-931-005) on the condition that the toner cartridge is not in end

• Overload on the toner transferring part (clogging of toner)

• Screw for detecting PCDU does not turn

• Detector element (sensor) defective: light leak

• Supplying pick does not engage

• Defective Supplying clutch

• Defective Drive mechanism of screw for supplying toner cartridge

• Turn the main power off/on.

SC364-00

D

Toner End Sensor output count error

When the average value of the toner end sensor output count is 0 n times consecutively (n: SP2-931-003)

• Connector contact failure/disconnected/broken

• Detector element (sensor) does not emit light

• Detecting surface inside the developing device is stained

• Turn the main power off/on.