The booklet unit is adjusted for optimum performance before the finisher is shipped from the factory. Do this adjustment only if the edges of folded booklets are not even.
Run a fold/staple job through the booklet unit with A3 (or DLT) paper.
Hold the folded sheet with the creased side pointing down and face-up (the same way that it came out of the finisher).
Referring to the diagram below, determine if the skew is [A] or [B].
[A] indicates that the rear fence is low and must be raised.
[B] indicates that the front fence is low and must be raised.
Preparation
Pull the stack/staple unit out with handle Rb12
Remove the lower inner cover Rb10, Rb11
Before doing any adjustment:
Rotate the knob counter-clockwise
so that it is loose.
Rotate the knob clockwise
until you feel some resistance, then stop.
Remove the screw.
- There is only one screw to remove. Check both holes.
- The screw may be at the front or at the rear, depending on where it was attached before shipping from the factory.