After you unpack the E-24B, connect the E-24B to the copier before you connect it to the network. This is to confirm that there are no problems with the hardware and controller itself.

  • Before doing the following steps, turn OFF the controller main power switch and copier main power switch, and disconnect the power cords.

  1. Remove the slot cover [A].
  2. Insert the Gigabit Ethernet PCB [A] and fasten it.
  3. Connect the interface cable to the copier Gigabit Ethernet port and then fix it with the protection plate [A].
  4. Connect the power cord of the copier to a power outlet.
  5. Connect the interface cable [A] to the lower Ethernet port of the E-24B.
  6. Attach the protector plate [B].
  7. Connect the appropriate AC power cord to the power connector at the rear of the E-24B.
  8. Attach the Fiery key top decal [A] to the area above the function key to which the Fiery function is assigned.
    For information on function key configuration, see the Operating Instructions.
  9. Attach the Fiery Decal [A] to the copier front cover.