Before you can use double-feed detection you must first enable the double-feed detection setting, and then set the detection sensitivity.

  1. Make sure that the machine is fully reassembled.
  2. Connect the machine to the power source and turn it on.
  3. Go into the SP mode.
  4. Open SP6040-001, and then set it to "1" (On). This enables double-feed detection.
  5. Next, open SP6040-008 to adjust double-feed sensitivity.
  6. Set an original in the ADF, and then press [Start]. (If you set more than one original, only one will feed.)
  7. Touch "EXECUTE" to feed one sheet
    • The sensitivity setting for one sheet is written into flash memory.
    • The machine displays the "Completed" message. This tells you the setting was successfully stored.
      -or-
    • If the machine displays the "Failed" message, repeat the procedure.
  8. Touch "CLOSE".
  9. Open SP6040-009 to see the value of the registered setting.
  10. Touch "EXECUTE".
  11. When you see the "COMPLETE" message, touch "CLOSE".
  12. You will see the sensitivity setting displayed below the "EXECUTE" button on the screen.