1. Feed unit Feed Unit, Pick-Up Roller
  2. Pick-up roller unit [A]

    • Pull the unit away from the bushings in the direction of the arrow.

  3. Feed belt holder [B]

    • Hold the feed belt holder by the sides, then lift up to separate from the holder.
    • Pull slowly to avoid losing the springs.

  4. Feed belt [C]
Re-assembly
  1. Position the pick-up roller unit [A] and feed belt holder [B] as shown above.
  2. On the rear side, slide out the bushing, and rotate [D] until its flat side is parallel with [E], then snap it on.
  3. On the front side, rotate [F] until its flat side is parallel with [D], then snap it on. Viewed from the bottom, the plates must be aligned.