• When installing this option, turn the power to the machine off, and unplug the power plug from the wall socket.
  • If this option is installed when the power is on, it will result in an electric shock or a malfunction.

  • When installing this option together with the “Internal Finisher SR3130”, attach this option first before installing the “Internal Finisher SR3130”

  1. Take out from the box, and remove the filament tape and packing material.
  2. Perform steps 1 to 22 of the installation procedure for the "Internal finisher SR3130".
  3. Change the position of the bracket [A] on the bottom plate (×1).
  4. Replace the lock holder of the bottom plate with the lock holder [A] provided (×1).
  5. Attach the upper front cover.
  6. Pass the shafts [B] of the punch unit [A] through the bearings [C] in the bottom plate, and attach the punch unit to the machine (×1, knob screw).

  7. Attach the front right cover [A] provided with the punch unit, inserting the claws (×1).
  8. Insert the hopper [A].

  9. Slide the finisher [A] along the rail of the bottom plate from the left of the machine, and then attach it (×1).

    • Before fastening the screw, make sure that the finisher is correctly set in the rail of the bottom plate.

    • When installing the punch unit in a finisher which is already installed, remove the entrance guide plate [A] (×2). Note that this step is unnecessary when installing the finisher and punch unit at the same time.

  10. Attach the lower rear cover [A] and the lower front cover [B] to the finisher (×2).
  11. Attach the left rear cover to the machine.
  12. Insert the upper left cover [A] from the front, and then attach it (x1).
  13. Connect the interface cable [A] to the machine.
  14. Turn the main power switch on.
  15. Check that the finisher can be selected at the operation panel, and check the finisher and punch operation.