1. Remove the decurler unit (Decurler Unit)
  2. On the front side, remove the rack of the front pinion gear (x1).
  3. On the rear side, remove the rack of the rear pinion gear (x1).
  4. In the center, disconnect the tongue bracket (x2).

  5. Remove the decurler unit assembly [A] so that you can see both sensors [B].

    • [A] is the decurler unit HP sensor and [B] is the decurler unit limit sensor.

  6. Disconnect the sensor that you wish to replace (x1).
  7. On the other side [C] (shown above) of the unit, release the sensor (x3).