Solution
B/W mode
In “Custom Paper Settings”, select “022: [Image Transfer Current: B&W]”.
Check the current value. Is it 60
A or less?
Yes
Carry out all of the following measures;
Increase the current value by 5
Set “033: [Paper Transfer Current; Trail Edge: B&W]” to "200%".
Set “034: [Ppr Transfer Current Trail Edg Dist: BW]” to "30 mm".
No
No further improvement can be expected in the field.
Print the target image. Is the problem solved?
Yes
Finish
No
Increase the image transfer current by 5
FC, FCS mode
In “Custom Paper Settings”, select “023: [Image Transfer Current: FC: Black]”.
Check the current value. Is it “60
Yes
Carry out all of the following measures;
Increase the current value by 5
Set “041: [Paper Transfer Current; Trail Edge: FC]” to "200%".
Set “042: “Ppr Transfer Current Trail Edg Dist: FC]” to "30 mm".
No
No further improvement can be expected in the field.
Print the target image. Is the problem solved?
Yes
Finish
No
Increase the image transfer current by 5
S only mode
In Custom Paper Settings, select [028: Image Transfer Current: Special].
Check the current value. Is it 60
Yes
Carry out all of the following:
Increase the current value by 5
Set [047: Paper Transfer Current; Trail Edge: S] to "200%".
Set [048: Ppr Transfer Current Trail Edg Dist: S] to "30 mm".
No
No applicable measures.
Print the image. Is the problem solved?
Yes
Finish
No
Increase the image transfer current by 5
Changing the transfer current may cause the following side effects.
Uneven density becomes easy to be outstanding.
If the guide plate is removed, toner scatter between lines may occur. (Toner Scattering: Lines
)
After taking the above measures, do the color calibration adjustment of the external controller.
