Solution

The measure for uneven image density varies depending on whether the area within 90 mm of the trailing edge is lower or higher.

• If the area within 90 mm of the trailing edge is lower;

  1. Check the value of “015: [Transfer Timing Roller Feed Speed Adj]” in “Custom Paper Settings”. Is the value higher than +0.5%?

     Yes	No further improvement can be expected in the field.
     No	Increase the value by 0.1%/step.

  2. Print the target image. Is the problem solved?

     Yes	Finish
     No	Repeat steps 1 and 2. If the problem is not solved by increasing the value to +0.5%, no further improvement can be expected in the field.

• If the area within 90 mm of the trailing edge is higher;

  1. Check the value of “015: [Transfer Timing Roller Feed Speed Adj]” in “Custom Paper Settings”. Is the value lower than -0.5%?

     Yes	No further improvement can be expected in the field.
     No	Decrease the value by 0.1%/step.

  2. Print the target image. Is the problem solved?

     Yes	Finish
     No	Repeat steps 1 and 2. If the problem is not solved by decreasing the value to -0.5%, no further improvement can be expected in the field.