Solution
Execute commands in the following order: “Adjusting the disengage timing of paper transfer” ”Adjusting the paper transfer current at the trailing edge”.
Adjusting the disengage timing of paper transfer
As a side effect, shock jitter may increase when the paper is disengaged.
*1: Correction values for the paper transfer
Length of unprinted area on trailing edge (mm) |
Process Speed Setting: |
||
[High] |
[Middle] |
[Low] |
|
1 |
-3 |
-3 |
-6 |
2 |
-6 |
-6 |
-12 |
3 |
-9 |
-9 |
-18 |
4 |
-12 |
-12 |
-24 |
5 |
-15 |
-15 |
-30 |
6 |
-18 |
-18 |
-36 |
7 |
-21 |
-21 |
-42 |
8 |
-24 |
-24 |
-48 |
Set the setting of Adjust Disengage Timing of Paper Transfer (No.83/ No.84/ No.85)” to the lower limit if the setting value of these is below the lower limit (+77) after this calculation (current value + each correction value shown above).
Adjusting the paper transfer current at the trailing edge
The applicable numbers for the items in the “Custom Paper Settings” vary depending on the printing mode of the machine. Refer to Applied Setting Items for Custom Paper Setting
about which number you need to adjust.
