Solution
This measure only works when the thickness of the paper is equivalent to paper weight 4 or higher. Do not try this as a measure when using paper with a thickness equivalent to paper weight 3 or lower, as it may cause paper misfeeding.
Execute commands in the following order: “Adjusting the gap of paper transfer”
“Adjusting the target constant voltage”.
Adjusting the gap of paper transfer
Adjusting the target constant voltage
*1 Settings to adjust for the paper transfer constant voltage
Printing mode |
Custom Paper Settings |
|---|---|
B/W |
064: [Ppr Trnsf Cnstnt Voltage: B&W: Side 1] 065: [Ppr Trnsf Cnstnt Voltage: B&W: Side 2] |
FC, FCS, FCS Quality |
070: [Ppr Trnsf Constant Voltage: FC: Side 1] 071: [Ppr Trnsf Constant Voltage: FC: Side 2] |
S only |
076: [Ppr Trnsf Constant Voltage: S: Side 1] 077: [Ppr Trnsf Constant Voltage: S: Side 2] |
*2 Excessive increase or decrease of the paper transfer constant voltage may increase the unprinted area on the leading edge. In such cases, gradually return toward the original value by steps of 0.5kV and adjust to a value which does not cause increased unprinted area.
After taking the above measures, do the color calibration adjustment of the external controller.
