Ring Binder Recognition: SC756-48
In a system where the Ring Binder is installed, there may be cases when the main machine issues SC756-48 (Ring Binder: Ring Binder Not Detected) when the Ring Binder door is opened, the ring binder unit is pulled out of the machine, upon recovery from low energy mode, or when the main machine is turned on.
Occasionally, closing the door will not release SC756-48.
If you are not using ring binding function, the machine can still be running; however, if you are using the function, SC756-48 pops up on the operation panel when selecting ring binding function.
Cause:
If the system is powered on with the ring binder unit pulled out, the ring binding system may not start up normally.
Solution:
Be sure not to exit from Energy Saver mode or to switch the machine on when the ring binder door is open and the binding unit is disconnected. Doing so will affect initialization, causing the ring binder function to become unavailable (although other functions will be unaffected).
If you inadvertently do this, connect the ring binder's binding unit again, close the door, and then turn the power off and back on to restore normal operation.
The system recovers from low energy mode, or is powered on, with the ring binder unit pulled out of the machine.
The machine issues SC756-48 on the operation panel.
The ring binder reset and the door was closed.
When the ring binder function is selected for use, SC756
-48 pops up on the operation panel.
Wait for the current copy or print job to end, and then cycle the main machine off/on.
Does SC756-48 display again, even after cycling the machine off/on?
Yes
The Ring Binder is malfunctioning. The problem requires further investigation, so consult key operators.
No
Finished!
For more detail, refer to SC700 (Service Call 750-790
)
