Turn the main power switch off.
Remove the slot cover [A] (
Insert the SD card into SD Card Slot 2 [B].
Make sure the label on the SD card faces the front side of the machine.
Slowly push the SD card into the slot so it locks in place. You will hear it click. Make sure the SD card locks in place.
To remove the SD, push it in to unlock the spring lock. Then release it so it pops out of the slot.
Disconnect the network cable if the machine is connected to a network.
Turn the main power switch on.
After a few seconds, the initial version update screen appears on the LCD in English.
On the screen, press the corresponding key (
,
) to select the update file that you want to update.
ROM/NEW |
What it means |
|---|---|
ROM: |
Tells you the number of the module and name of the version currently installed. |
NEW: |
Tells you the number of the module and name version on the SD card. |
You can change the module name screen or module version screen by using
,
keys.
Controller and engine firmware cannot be updated at the same time. It is recommended to update firmware modules one by one.
Press the "OK" key after selecting the item that you want to update.
The "UpDate" button appears.
Press the "UpDate" key to start the update.
The progress bar appears on the operation panel.
The "Update Done" message appears after completing the updating.
The message differs depending on the firmware that has been updated.
Turn the main power off and on. Then, select the items that you updated, and then push the [Verify] button.
This is to check that the modules were updated correctly. Press in the SD card to release it. Then remove it from the slot.
If you see "Verify Error" in the first bar on the screen, then you must do the procedure again for the module shown in the bottom bar.
The "Verify" procedure is not necessary but it is strongly recommended.
After the firmware is correctly updated, turn the main power switch off, and then switch the machine on for normal operation.