When you install this option to the main machine for the first time, the interface board must be connected directly to your PC to set up the IP address and other network settings.
Turn off the main power switch, and unplug the power cord from the wall socket.
Remove the interface slot cover. (
Insert the interface board into the interface slot [A] (
Insert the USB connector into the USB port on this option.
Insert the other side of the USB connector into the USB port B on the main machine.
The machine shape and/or USB port location differs depending on the machine.
Mount the ferrite cores on the Ethernet cable, while looping the cable at 3 cm (approx. 1.2 inch) [A] from the each end of the cable.
Insert the Ethernet cable into the Ethernet board on this option.
Insert the other end of the Ethernet cable to a PC for network setting.
Plug the power cord into the wall socket and turn on the main power switch.
Do not unplug the USB connector while the machine is recognizing this option. It may take between 30 seconds to 1 minute to finish recognizing it (the LEDs by the connector light up when finished; see below). If unplugged, connect the cable again.