Remove the right lower cover. (Right Lower Cover
)
Remove the bracket [A].
Disconnect the USB connector [A] of the operation panel.
Disconnect the two flat cables and two connectors.
Make sure to open the flap before disconnecting the flat cable [A], as shown in the following pictures. Otherwise, the connector may be damaged.
When disconnecting the flat cable [A], pull it out in the direction of the arrow.
Release the flat cable and harness from the harness guides.
Remove the seven screws from the controller box [A].
The screw [B] is a tapping screw. Be careful not to use the wrong screw when installing the controller box.
Release the hook [A], and then remove the controller box [B] by rotating it counter-clockwise.
When installing the controller box [A], make sure to secure the harness and flat cable to the harness guides, as shown below.
When installing the bracket [A] of the controller box [B], do not interpose the harness and the flat cable between the bracket and the controller box.
