Top Page > Main Chapters > Installation > USB Device Server Option Type M19 (D3BC-28, 29) > Installation Procedure
When you install this option to the main machine for the first time, the interface board must be connected directly to your PC to set up the IP address and other network settings.
Turn OFF the main power, and unplug the machine power cord before starting the following procedure.
Loosen the two screws and remove the slot cover [A] from the rear side of the machine.
Fully insert the interface board [A].
Tighten the two screws to secure the interface board.
Using the supplied USB cable [A], connect the USB device server to the machine.
Mount the ferrite cores on the Ethernet cable, while looping the cable at 3 cm (approx. 1.2 inch) [A] from the each end of the cable.
Only when installing this option in NA, fix each ferrite core with the cable tie [A].
Insert the Ethernet cable [A] into the Ethernet board on this option.
Insert the other end of the Ethernet cable to a PC for network setting.
Plug the power cord into the wall socket and turn ON the main power.
