Turn OFF the main power, and unplug the machine power cord before starting the following procedure.
Open the rear upper cover [A].
Insert a flathead screwdriver into [A] to release the hook on the inside of the controller cover [B].
Release the hook by opening the right side of the cover, and then remove the cover [A] by rotating it in the direction of the blue arrow.
Be careful not to damage the hooks on the inside of the controller cover when you remove or install the controller cover.
Insert a flathead screwdriver in the order of
Remove the rear left stay [A].
Be careful not to damage the hooks on the inside of the rear left stay when you remove or install the rear left stay.
Push the button [A] and open the front cover [B].
Release the hook [A] of the right upper cover [B] by opening the cover in the direction of the arrow.
Remove the right upper cover [A] by inserting a flathead screwdriver into [B].
Be careful not to damage the hooks on the inside of the right upper cover when you remove or install the right upper cover.
Insert a flathead screwdriver at [A] to release the hook of the scanner front cover [B].
Release the two hooks of the scanner front cover [A].
Insert a flathead screwdriver at [A] to release the hook, and then remove the scanner front cover [B].
Be careful not to damage the hooks on the inside of the scanner front cover when you remove or install the scanner front cover.
Release the two hooks of the operation panel arm upper cover [A].
Insert a flathead screwdriver into [A] to release the hook, and then remove the operation panel arm upper cover [B].
Be careful not to damage the hooks on the inside of the operation panel arm upper cover when you remove or install the operation panel arm upper cover.
Remove the hinge cover [A] from the operation panel. (hook×2)
Make a loop at the end of the USB cable [A], and then attach the ferrite core [B], as shown below.
Attach the ferrite core at a distance of 4.0 cm (1.6 inch) [A] from the end of USB cable.
Peel off the conductive tape [A] from the USB cable [B].
Insert the USB cable [A] into the media slot of the operation panel.
Insert the end [A] of the USB cable, where the ferrite core is not attached, into the media slot of the operation panel.
Route the USB cable [A] to the right side of the machine. (hook×2)
Secure the USB cable [A] with the clamp.
Remove the screw [A] from the operation panel arm.
Install the FG clamp [A] to the operation panel arm.
When installing the FG clamp, bind the USB cable [B] with the FG clamp [A]. Make sure to bind the part where the coating is stripped partially.
When installing the FG clamp [A], use the screw provided with NFC Card Reader Type M24.
Attach the hook and loop fastener [A] to the base cover [B] at the position shown below.
Peel off the mount from the hook and loop fastener, and then attach the NFC card reader [A] to the base cover [B] at the position shown below.
Attach the NFC card reader with the USB port [A] of the NFC card reader set to face right.
Peel off the mount [A] of the seal from the back side [B] of the base cover.
Fit the notch part [A] of the base cover [B] into the right upper cover [C] of the main machine, and then attach it.
Reattach the right upper cover [A] to the main machine.
When attaching the right upper cover, pull out the USB cable [A] through the notch [B] in the right upper cover.
Connect the USB cable [A] to the NFC card reader [B].
Attach the upper cover [A] to the base cover [B].
Reassemble the machine.
