Installation
Initializing the Developer and ID Sensor
Important Notice on Security Issues
Rails and Front Positioning Pins
Flat Cable and Roll Feeder Tray
Roll Feeder Drawer Positioning
Roll Feeder Heater Switch Decal
Attach Guide Screws, Caution Decal
Set and Connect the Heater Harness
Fasten the Paper Cassette Drawer
Attach End Plates, Connect Heater Harness
Attach Decals, Turn Heater Switch On
Moving Applications on to One SD Card
IEEE 802.11 a/g/n Interface Unit Type M2
Data Overwrite Security Unit Type I
Check Operation of the DOS Application
When the original SD card exists
SD Card for Network Printing Type M14
Scanner Separation Kit Type M14
Scanner Separation Unit Accessories
Disconnect SIB-IPU Cable (Signal Cable)
Disconnect Operation Panel USB Cable
Remove the Disconnected Harnesses from Main Unit
Remove Scanner Unit and Mount It on the Table
Attach Harness Bracket to the Back of the Main Machine
Connect Signal Harness (SIB-IPU)
Connect Operation Panel Harness
Attach Ferrite Cores to SIB Harnesses
Attach Ferrite Core on Left Side of Machine
Fasten Ground Wires: Left Side